Effect of Filler Ratio in Adhesive Systems on the Shear Bond Strength of Resin Composite to Porcelains

Guler A. U., Sarikaya I. B., Guler E., Yucel A. C.

OPERATIVE DENTISTRY, vol.34, no.3, pp.299-305, 2009 (SCI-Expanded) identifier identifier

  • Publication Type: Article / Article
  • Volume: 34 Issue: 3
  • Publication Date: 2009
  • Doi Number: 10.2341/08-88
  • Journal Name: OPERATIVE DENTISTRY
  • Journal Indexes: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Page Numbers: pp.299-305
  • Ondokuz Mayıs University Affiliated: Yes

Abstract

This in vitro study evaluated the effect of six different adhesive systems on the shear bond strength of resin composite to feldspathic and low-fusing porcelains. Sixty porcelain blocks were prepared for each low-fusing (Matchmaker) and feldspathic (MVK95) porcelain specimen. After surface preparation, the porcelain specimens were divided into six groups (n=10) for different adhesive systems (Adper Prompt L-Pop, QuadrantUni1 Bond, Te-Econom, PQ1, One-StepPlus and Prime&Bond NT). After adhesive application, a universal resin composite (FiltekZ250) was condensed on the specimens. The prepared specimens were then stored in distilled water at 37 degrees C for 24 hours, then all the samples were thermal cycled 1000 times between 5 degrees C and 55 degrees C. Shear testing was performed on a universal test machine using a crosshead speed of 0.5 mm/minute. The statistical analysis of the bond strength data included two-way ANOVA. Then, the means were compared by Tukey HSD test (alpha=0.05). The lowest bond strength was observed in Adper Prompt L-Pop. No statistically significant difference was observed between One-Step Plus and Prime&Bond NT. The highest bond strength was observed in PQ1. When low-fusing or feldspathic porcelain restorations are repaired with resin composite, self-etching adhesive systems may not be indicated. If maximum bond strength is the goal in porcelain resin bonding, adhesive systems that have a high filler ratio should be used.