Research Information System
JOURNAL OF ADVANCED PROSTHODONTICS, vol.15, no.3, pp.114-125, 2023 (SCI-Expanded)
PURPOSE. The aim of the study was to evaluate the optical properties of new generation (3Y-TZP) monolithic zirconia (MZ) with different abutment types and resin cement shades. MATERIALS AND METHODS. A1/LT MZ specimens were prepared (10 x 12 x 1 mm, N = 30) and divided into 3 groups according to cement shades as transparent (Tr), yellow (Y) and opaque (O). Abutment specimens were obtained from 4 different materials including zirconia (Group Z), hybrid (Group H), titanium (Group T) and anodized yellow titanium (Group AT). MZ and abutment specimens were then cemented. L*, a*, and b* parameters were obtained from MZ, MZ + abutment, and MZ + abutment + cement. increment E001* (between MZ and MZ + abutment), increment E002* (between MZ and MZ + abutment + cement) and increment E003* (between MZ + abutment and MZ + abutment + cement) values were calculated. Statistical analyses included 2-way ANOVA, Bonferroni, and Paired Sample t-Tests (P < .05). RESULTS. Abutment types and resin cements had significant effect on L*, a*, b*, increment E001*, increment E002*, and increment E003* values (P < .001). Without cementation, whereas zirconia abutment resulted in the least discoloration ( increment E001* = 0.68), titanium abutment caused the most discoloration ( increment E001* = 4.99). The least increment E002* = 0.68 value was seen using zirconia abutment after cementation with yellow shaded cement. Opaque shaded cement caused the most color change ( increment E003* = 5.24). Cement application increased the L* values in all groups. CONCLUSION. The least color change with/without cement was observed in crown configurations created with zirconia abutments. Zirconia and hybrid abutments produced significantly lower increment E002* and increment E003* values in combination with yellow shaded cement. The usage of opaque shaded cement in titanium/anodized titanium groups may enable the clinically unacceptable increment E00* value to reach the acceptable level. [J Adv Prosthodont 2023;15:114-25]